Need Stock FD Parts At A Good Price
Thread Starter
Joined: Mar 2001
Posts: 1,778
Likes: 1
From: ROSEVILLE, MN
Need Stock FD Parts At A Good Price
I’m rebuilding an FD motor and know I need two rotors and a complete gasket set.
The rotor will be milled out to install 3mm Hurley racing seals and double springs.
Any one have any recommendations where I might get a good price on these. I tried Mazdacomp, but they don’t do stock parts anymore.
Thanx,
Ken
The rotor will be milled out to install 3mm Hurley racing seals and double springs.
Any one have any recommendations where I might get a good price on these. I tried Mazdacomp, but they don’t do stock parts anymore.
Thanx,
Ken
Full Member
Joined: Mar 2002
Posts: 173
Likes: 0
From: Negative Ghost Rider, the pattern is full.
You might want to try here, if cheap is your primary concern:
http://www.mazdarecycling.com/
Not sure if they'll have everything you'll need, but it wouldn't hurt to give them a call.
http://www.mazdarecycling.com/
Not sure if they'll have everything you'll need, but it wouldn't hurt to give them a call.
Thread Starter
Joined: Mar 2001
Posts: 1,778
Likes: 1
From: ROSEVILLE, MN
Originally posted by M.Piedlourde
You might want to try here, if cheap is your primary concern:http://www.mazdarecycling.com/
Not sure if they'll have everything you'll need, but it wouldn't hurt to give them a call.
You might want to try here, if cheap is your primary concern:http://www.mazdarecycling.com/
Not sure if they'll have everything you'll need, but it wouldn't hurt to give them a call.
Ken
Thread
Thread Starter
Forum
Replies
Last Post
Jose A.
3rd Generation Specific (1993-2002)
19
Aug 27, 2015 11:41 PM