87 fc idle problem
#1
Junior Member
Thread Starter
Join Date: Apr 2015
Location: tennessee
Posts: 11
Likes: 0
Received 0 Likes
on
0 Posts
87 fc idle problem
New to Mazda the car starts and runs but drops under 1000 rpm then dies it used to only do it on first cold start and now even when it's hot it will drive just fine untill I stop then dies where should I start looking? R2 basicly stock
#4
Moderator
iTrader: (3)
welcome to the board.
i will assume "R2" is supposed to be T2???
how long have you had the car and has it EVER idled normally since you had it? have you done any engine work recently?
how did you check for leaks? too many times people have said/believed they checked for all vacuum leaks, and still had a leak.
i will assume "R2" is supposed to be T2???
how long have you had the car and has it EVER idled normally since you had it? have you done any engine work recently?
how did you check for leaks? too many times people have said/believed they checked for all vacuum leaks, and still had a leak.
#5
Junior Member
Thread Starter
Join Date: Apr 2015
Location: tennessee
Posts: 11
Likes: 0
Received 0 Likes
on
0 Posts
welcome to the board.
i will assume "R2" is supposed to be T2???
how long have you had the car and has it EVER idled normally since you had it? have you done any engine work recently?
how did you check for leaks? too many times people have said/believed they checked for all vacuum leaks, and still had a leak.
i will assume "R2" is supposed to be T2???
how long have you had the car and has it EVER idled normally since you had it? have you done any engine work recently?
how did you check for leaks? too many times people have said/believed they checked for all vacuum leaks, and still had a leak.
Trending Topics
#8
Junior Member
Thread Starter
Join Date: Apr 2015
Location: tennessee
Posts: 11
Likes: 0
Received 0 Likes
on
0 Posts
well, i still say get a vacuum diagram and go through the system, but i'll stop badgering you there.
have you given it a tuneup since you got it? since this happened overnight, you can also check to see if the CAS is loose.
just to satisfy my own curiosity, what is R2?
have you given it a tuneup since you got it? since this happened overnight, you can also check to see if the CAS is loose.
just to satisfy my own curiosity, what is R2?
#9
Junior Member
Thread Starter
Join Date: Apr 2015
Location: tennessee
Posts: 11
Likes: 0
Received 0 Likes
on
0 Posts
#10
Junior Member
Thread Starter
Join Date: Apr 2015
Location: tennessee
Posts: 11
Likes: 0
Received 0 Likes
on
0 Posts
#12
Junior Member
Thread Starter
Join Date: Apr 2015
Location: tennessee
Posts: 11
Likes: 0
Received 0 Likes
on
0 Posts
Crank angle sensor it's not loose no vacuum leaks and took the fuel filter off and it ran fine for a few min then started dying again but it wasn't clogged don't know what elts to look at
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM