Wolf 3D Discuss the Wolf 3D Engine Management System

Wolf 3D Wolf V4+: what Sarting Fuel Rate do you guy use at?...

Thread Tools
 
Search this Thread
 
Old Sep 10, 2006 | 10:25 PM
  #1  
06fc3s's Avatar
Thread Starter
TIME ATTACK FD
Tenured Member 10 Years
iTrader: (8)
 
Joined: Feb 2006
Posts: 624
Likes: 0
From: Silicon Valley, CA
Wolf V4+: what Sarting Fuel Rate do you guy use at?...

Starting Fuel Rate do you use?.... mine is some where along the lines of 10.00-10.14 millisec. yet, i dont know if that is too much or too less... any ideas?
O yea iam running a Wolf 3d V4+ if it makes any difference.. thanks.
Reply
Old Sep 11, 2006 | 04:47 AM
  #3  
CrackHeadMel's Avatar
Learned alot | Alot to go
Tenured Member 20 Years
iTrader: (2)
 
Joined: Apr 2002
Posts: 4,232
Likes: 0
From: Rotaryland, New Hampshire
mines 10.xx when its warm out

on the cold mornings (50 or less) it climbes much higher, 14, 15 etc when its freezing out i have seen 17's
Reply
Old Sep 11, 2006 | 04:33 PM
  #4  
Michael Smith's Avatar
Rotary Enthusiast
Tenured Member 10 Years
 
Joined: Feb 2004
Posts: 778
Likes: 0
From: North Queensland Australia
Mine pumps out to 22 on a cold winters morning About 10 when hot. Mine runs pig rich at startup as you can imagine.

Michael Smith
Reply
Old Sep 11, 2006 | 09:31 PM
  #5  
06fc3s's Avatar
Thread Starter
TIME ATTACK FD
Tenured Member 10 Years
iTrader: (8)
 
Joined: Feb 2006
Posts: 624
Likes: 0
From: Silicon Valley, CA
hmmm.. are all yours automactically adjusted depending on the ambient temp. or do you actually manually set it when winter comes rolling around?.. i also raise the SFR during the winter but not by much higest was probably 12.xx if i go any high the car seems to flood and it takes a couple of tries to start it up, this only happens in the winter though.
Reply
Old Sep 12, 2006 | 06:20 PM
  #6  
CrackHeadMel's Avatar
Learned alot | Alot to go
Tenured Member 20 Years
iTrader: (2)
 
Joined: Apr 2002
Posts: 4,232
Likes: 0
From: Rotaryland, New Hampshire
mines automatic, althoug thers been a few times ive had to adjust it manual because, well.. im new to all this. never to much though
Reply
Old Sep 13, 2006 | 08:16 AM
  #7  
pilot's Avatar
Full Member
Tenured Member 05 Years
 
Joined: Mar 2006
Posts: 53
Likes: 0
From: Argentina
So engine temp modifiers changes starting fuel pulses?
Reply
Old Sep 13, 2006 | 08:28 AM
  #8  
Michael Smith's Avatar
Rotary Enthusiast
Tenured Member 10 Years
 
Joined: Feb 2004
Posts: 778
Likes: 0
From: North Queensland Australia
Air temp and engine temp.
Mine changes, I am not sure what goes on but mine does change.

Cheers
Michael Smith
Reply
Old Sep 13, 2006 | 09:00 PM
  #9  
06fc3s's Avatar
Thread Starter
TIME ATTACK FD
Tenured Member 10 Years
iTrader: (8)
 
Joined: Feb 2006
Posts: 624
Likes: 0
From: Silicon Valley, CA
what exactly is the engine temp. that shows on the Wolf 3d display is it showing the WATER temp. or the actaully temps of the engine....
Reply
Old Sep 14, 2006 | 04:36 AM
  #10  
nyt's Avatar
nyt
Rotary Enthusiast
Tenured Member 20 Years
iTrader: (1)
 
Joined: Feb 2001
Posts: 1,259
Likes: 4
From: long island
water temp, but when youre starting yoru car, theyll be the same
Reply
Old Sep 14, 2006 | 06:10 AM
  #11  
Michael Smith's Avatar
Rotary Enthusiast
Tenured Member 10 Years
 
Joined: Feb 2004
Posts: 778
Likes: 0
From: North Queensland Australia
When I get my auto back in and remounted I will note the settings. I am sure mine changes.

Michael Smith
Reply
Old Oct 1, 2006 | 02:45 PM
  #12  
signofinfinity's Avatar
Coyote
Tenured Member 05 Years
 
Joined: Nov 2004
Posts: 953
Likes: 0
From: Malta. Europe
they do change. once yu move that table for compensation the fuel moves!

i start using 6.68ms in all..... 1000 primaries

stochiometric idle.... finally
Reply
Old Oct 1, 2006 | 02:49 PM
  #13  
CrackHeadMel's Avatar
Learned alot | Alot to go
Tenured Member 20 Years
iTrader: (2)
 
Joined: Apr 2002
Posts: 4,232
Likes: 0
From: Rotaryland, New Hampshire
Originally Posted by signofinfinity
they do change. once yu move that table for compensation the fuel moves!

i start using 6.68ms in all..... 1000 primaries

stochiometric idle.... finally

your car idles at lamba 1??
Reply
Old Oct 1, 2006 | 04:11 PM
  #14  
signofinfinity's Avatar
Coyote
Tenured Member 05 Years
 
Joined: Nov 2004
Posts: 953
Likes: 0
From: Malta. Europe
well, i can say its stochiometric through my secondary stochiometer. i will hook up my wideband this week. I finally got my car started after january, with the new fuel/ oil/ turbo systems.

It idles bang on the stochiometric region on the dial!


Cheers!
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Tylerx7fb
1st Generation Specific (1979-1985)
39
May 27, 2019 12:45 PM
Clacor
Single Turbo RX-7's
0
Aug 14, 2015 09:17 AM




All times are GMT -5. The time now is 11:29 AM.