I have a wolf 3d v4 that i wired into my car. im using a fd ignitor and unmodified cas. the car is an 88 t2and i removed every wiring harness and only have the wolf wired in. i have tried a few diferent maps like the s5 base map and a few of singofinfinitys. i can not get a spark out of any coils but the light blinks on the wolf when turning over. Also when turning over the laptop says im at 1500rpm i think thats a little to high. Any thoughts from more experienced users?

 

Im running an unmodified cas and a fd ignitor running fc coils (well fd ignitor's only firing the trailing in mysetup)

What did you use for a wiring diagram on the ignitor

Are you sure the ignitor is getting power

 

i used nyts diagram for the ignitor and yes its getting power. but i dont think that is the issue wich the1500- 1600 cranking rpm it should be like 200 and some shouldnt it

 

what are your ignition settings?

 

i got it running and when i had the stock cas in i did have it set for a unmodified. i modified it today and then changed the settings for a modified cas and it then read the correct rpm. i also did not have power to my ignitor due to a me forgeting what my helper told me. thanks for helpin out guys.