Wolf 3D Windows Vista and V4.72
#1
Junior Member
Thread Starter
Join Date: Aug 2007
Location: South Africa
Posts: 6
Likes: 0
Received 0 Likes
on
0 Posts
Windows Vista and V4.72
Is anyone here having a problem with Windows Vista and the Wolf V4?? The problem I have is that it will not connect to the ECU and when it does, it stops responding, either while downloading the map or while you are working with it.
Is there any way of getting past this issue?? I have contacted Wolf agents in Aus and they arent much help, seems l;ike they are to busy focussing on V500.
Is there any way of getting past this issue?? I have contacted Wolf agents in Aus and they arent much help, seems l;ike they are to busy focussing on V500.
#2
watashi no shichi
iTrader: (4)
for Windows 2003 - I had to apply a "Legacy Hardware" patch to the o/s for serial/lpt/com use.
http://support.microsoft.com/kb/838291
...but again, i doubt this is your problem.
http://support.microsoft.com/kb/838291
...but again, i doubt this is your problem.
#3
Junior Member
Thread Starter
Join Date: Aug 2007
Location: South Africa
Posts: 6
Likes: 0
Received 0 Likes
on
0 Posts
What problems were you experiancing?? How did you find out that that was a fix?? Would Microsoft know anything about this matter?? Any ideas how I could solve this problem??
Thread
Thread Starter
Forum
Replies
Last Post