Im using this on along side with my powerfc + datalogit.

The real world values i'd say are pretty close to a real rolling road dyno.
I had last dyno'd my car at 194RWKW (270RWHP) on a slightly hotter day and less aggressive tune.

If anyone sends a log file I can give it a go and see if it opens up.

 

Hey I have emailed them and offered data for V4 so it can be added to the support list. It would be good if someone with V500 experience and logs could supply data too!! We will have to wait and see!!

Cheers
Michael Smith

 

Calling for datalogs from V4, V400 and V500's ....I am looking for people who can supply me with log to help get the Wolf supported by DataLogLab. What needs to be done is basically turn on your ignition start the laptop start the V4 or V500 software. Write down all the data without the engine running. Stop the logging. Turn off the car. Then do it again this time start the car and log the car until Hot. Take note of the idle rpm and temps rough duty cycle. Stop the logging and the car.
Again turn on your ignition start the laptop start the V4 or V500 software without starting the car and write down all the readings.

Ok one more thing log a nice drive and thats it. No other data required here.


After each log use a text editor to write all the readings and name it the same as the log file with the .txt extension. It would be good if you had the basic specs but injector sizes would be ok. If you can help please pm me and I will give you my email address. I will collate the data and forward it on to DataLogLab and maybe we will see the Wolf supported

Cheers
Michael Smith