Any guys here have a clue how to wire in the LM1 or any datalogger to read the internal map sensor of wolf? I run the PnP vers of the Wolf for the FD.....

Is it a good idea to log MAP from the map sensor of the Apexi AVCR? I tap into that wire and log my boost/vacuum regions from there?

Thanks all.....

 

That was the mod that Dave had made to the Wolf wasn't it??? It looked like it was off the internal MAP sensor. However all you need to do is setup a second map sensor or even the old factory one and read the data all you need to do is using your pressure/vac gun out and read the voltage of the new map against the load value. With the logger you can read the load in real time.
Cheers
Michael Smith

 

Thanks mike... that was the reason i was going for the 3 bar map sensor...... but i just wanted a generic idea.... that line connector might be for logging, it seem to come off the map sensor....