Wolf 3D Could do with a map to start my modded FD.
Thread Starter
Let The Build Begin
Joined: Jun 2008
Posts: 50
Likes: 0
From: Australia Somewhere
Could do with a map to start my modded FD.
Have not had much luck with the wolf base map. Can get started on a good day but have to keep a bit of gas on. Cant get above 3000 rpm and runs ruff (this is just starting, cant even think about driving).
Twins still there, have a single ready to fabricate in once it starts and runs,
Full BP,
Standard injectors,
3" exhaust,
V500 with adapter loom,
Twins still there, have a single ready to fabricate in once it starts and runs,
Full BP,
Standard injectors,
3" exhaust,
V500 with adapter loom,
Thread Starter
Let The Build Begin
Joined: Jun 2008
Posts: 50
Likes: 0
From: Australia Somewhere
Just an update
Talked to Robbie from wolf again (very helpful feller). The map that came in the chip designed by Robbie had a 3000 rev limit and was an extremely simplified version of the "S6 shipping map 001" of what. Just found this out today, called Robbie because on set map no inj. or ignition indicators lighting up on crank over. Waiting on another map via e-mail.
Thread
Thread Starter
Forum
Replies
Last Post
82streetracer
Haltech Forum
11
Mar 11, 2019 05:34 PM
befarrer
Microtech
3
Aug 22, 2015 05:52 PM