Do any of you guys here do suspension bushings? I have some nylon bushings that I want to replaced with polyurethane or stock. Or if you know a shop that doesn't charge a gazillion dollars, that would work too. I probably need to replace the front upper/lower control arm bushings, and the rear upper control arm bushings. Just reply or pm me.

Thanks!

 

I believe Wan does but he is in SoCal...

 

I would say Wan. but like charlie said hes in so-cal

 

i could do it, but again... socal.

 

Karack in Yuba city... if you could get a hold of him?

 

^Yeah he could do it...hes not a fan of it lol but he'll do it

 

lol doesn't he have like 10 cars to work on. I remember trying to reach him at some point. Not the easiest thing to do...

 

He can't take on more rebuilds I think, but bushings is like a one day thing...

 

Come to So Cal and I'll do them for you. Use it as an excuse to take a vacation out here and enjoy the sights while your bushings are being done

 

I think ben quoted me at about 800~900 for the whole car (but if you only do the front then it'll be like 300~400ish...he said the back of the car is the pain in the ***)

 

yea supposedly no one likes doing the rear. Rotorsport doesn't like doing certain parts in the rear either.

 

Rear he said he'd have to drop the rear subframe. PITA lol I did my fronts and almost cracked my skull when the dowel I was using with my press flew out. Rears. I didn't do.

 

Call up Wan. He'll make you a shirt that says, "I came to socal to get my bushings done, and all i got was this T-shirt"

 

lol...

 

 

I had good experience with Matthel at the Shop down in San Bruno - his shop's close to the BART station.

https://www.rx7club.com/west-rx-7-forum-193/review-shop-san-bruno-matthel-842931/

Good luck!
Allen

 

+1 for The Shop. I corner weighted/balanced/aligned my car there after I put in my new suspension setup.

 

**** that guy, he's a douche...

anyways, i can maybe do it next week. assuming you have the kit already. i don't remember quoting quite as high as 800-900 for a whole car but it would be probably around 500, or about 250 to do front only.