Badfighterpilot
Thread Starter
Generation Specific / 1st Generation Specific (1979-1985) May 15, 2026 11:47 PM
I wanted to see what people think about the t3 steering rack. I really would like a rack from mtheory and I know its probably better, but It is also 3x more expensive, and he may not make/have any...
joystick
Thread Starter
Generation Specific / 2nd Generation Specific (1986-1992) May 15, 2026 10:43 PM
Not quite sure why some of my replies are going and some aren't but here are some pictures that I've taken today. I was in the middle of troubleshooting which is why the intake tube is off and such....
Badfighterpilot
Thread Starter
1st Generation Specific (1979-1985) / Build Threads May 15, 2026 10:42 PM
Got her on the lift. My tig welding equipment is coming Tuesday so im hoping to get the exhaust done. Windows should be sometime next week. Other than that I have hang the fuel hoses, change the oil,...
Badfighterpilot
Thread Starter
Generation Specific / 1st Generation Specific (1979-1985) May 15, 2026 10:38 PM
yeti
If someone can get me the dimensions I'll create the model.
7beast
Thread Starter
Classifieds / The NEW RX7 Marketplace May 15, 2026 10:10 PM
Hey fellas im on the hunt for an aftermarket throttle body for my fd seeing if anyone has a good used one they would be willing to sell before I have to bite the bullet and buy one new.. Will pay for...
rookie117
Thread Starter
Generation Specific / 3rd Generation Specific (1993-2002) May 15, 2026 09:24 PM
1994 FD RX7. Just replaced my engine, old one was running fine. Now i have a misfire at 6k Rpms and at the same time my tach goes wild. The issue correlates with each other. Wideband also goes RICH...
tomsn16
Thread Starter
Classifieds / The NEW RX7 Marketplace May 15, 2026 08:14 PM
Fully functional Coilover Sets
$200...CXracing set................. .................... ...SOLD
$800....Koni ProPart set
Prices plus shipping
All my parts may be returned if not satisfied
Zatzy
Thread Starter
Engine Management Forum / Haltech Forum May 15, 2026 07:34 PM
Thank you for the response Ludwig. At this point I feel Im just going to leave everything. Yes the VE table is a tiny bit higher then everyone says it should be but the car runs amazing, is taking...
Tech and Performance / Race Car Tech May 15, 2026 07:08 PM
Renesis all day for a street driven car. You’ll spend money and time building a loud FC engine that doesn’t make as much power as a stock port Renesis.
Wouldn’t go for a taller rear gear either.
Generation Specific / 3rd Generation Specific (1993-2002) May 15, 2026 06:26 PM
Im in the same boat, I have a u.s. 93 auto to manual conversion. Im in need of repinning procedures. Thanks to anyone that can help.