LS1 Keeps Stalling after Reving... HELP!
#1
Rotartist
Thread Starter
iTrader: (13)
Join Date: Sep 2003
Location: Spring Hill TN 37174
Posts: 7,252
Likes: 0
Received 2 Likes
on
2 Posts
LS1 Keeps Stalling after Reving... HELP!
Here is the low down..
Running Atomic LS for fuel, ecu and ignition
Stock coils and injectors
Car falls on it's face and dies on it's way down from anything over 1/4 throttle it dips to about 300 rpm then dies or falls directly to its death.
Car is fine other then that. No error codes etc..
Any help would be great.. BTW, everything is new, every sensor, the entire harness... Engine, everthing.
The Valve Cover vents are open to atmosphere right now, with the ports on the TB and manifold blocked off..
Running Atomic LS for fuel, ecu and ignition
Stock coils and injectors
Car falls on it's face and dies on it's way down from anything over 1/4 throttle it dips to about 300 rpm then dies or falls directly to its death.
Car is fine other then that. No error codes etc..
Any help would be great.. BTW, everything is new, every sensor, the entire harness... Engine, everthing.
The Valve Cover vents are open to atmosphere right now, with the ports on the TB and manifold blocked off..
#4
my 01 camaro had this problem, but only after WOT. never found an answer, and shortly after finding out that this happened, i spun a rod bearing lol. not saying this will happen to you, just my experience. for a bit of reference, i had ported/polished/milled ls6 heads, a torquer v3 cam from TSP, intake and full exhaust. however my tuner sucked, so consider a retune. but my recommendation would be posting your problem on ls1tech. those guys are awesome.
#5
Rotartist
Thread Starter
iTrader: (13)
Join Date: Sep 2003
Location: Spring Hill TN 37174
Posts: 7,252
Likes: 0
Received 2 Likes
on
2 Posts
my 01 camaro had this problem, but only after WOT. never found an answer, and shortly after finding out that this happened, i spun a rod bearing lol. not saying this will happen to you, just my experience. for a bit of reference, i had ported/polished/milled ls6 heads, a torquer v3 cam from TSP, intake and full exhaust. however my tuner sucked, so consider a retune. but my recommendation would be posting your problem on ls1tech. those guys are awesome.
My engine is literally brand new out of the crate so I hope and doubt there will be spun bearing issues.
Thread
Thread Starter
Forum
Replies
Last Post