What FD BBK are these rotors from?
#1
Senior Member
Thread Starter
iTrader: (10)
Join Date: Oct 2002
Location: Greensboro, NC
Posts: 463
Likes: 0
Received 0 Likes
on
0 Posts
What FD BBK are these rotors from?
I have these rotors - does anyone know what kit they are from? I haven't see the aluminum locating pieces before -- I figure someone knows what they are from.
My thought is the Wilwood kit, possibly a Brembo setup,(although unlikely), and any other combinations......
I'm hoping the aluminum gives it away.
I can take more detailed pictures if required. I also have two different width of hats - the ones mounted, and a second set which is approx 1/2 the thickness?
The first picture shows it is a 355mm disc,(14"). It is 1.25" thick. The second picture is the two rotors, opposite sides,(a little dark on the upper left - sorry), and the extra set of hats - which other than thickness, are identical. The third picture is a side shot - something rubbed on the black anodized finish - and it is the same on both rotors. The last picture shows the two different thickness hats.
Any help/ideas is much appreciated. If you have pictures, even better!
-Bob
My thought is the Wilwood kit, possibly a Brembo setup,(although unlikely), and any other combinations......
I'm hoping the aluminum gives it away.
I can take more detailed pictures if required. I also have two different width of hats - the ones mounted, and a second set which is approx 1/2 the thickness?
The first picture shows it is a 355mm disc,(14"). It is 1.25" thick. The second picture is the two rotors, opposite sides,(a little dark on the upper left - sorry), and the extra set of hats - which other than thickness, are identical. The third picture is a side shot - something rubbed on the black anodized finish - and it is the same on both rotors. The last picture shows the two different thickness hats.
Any help/ideas is much appreciated. If you have pictures, even better!
-Bob
#3
Senior Member
Thread Starter
iTrader: (10)
Join Date: Oct 2002
Location: Greensboro, NC
Posts: 463
Likes: 0
Received 0 Likes
on
0 Posts
I'm about 90% certain. It came along with another RX-7 and only RX-7 parts came with it. I'd be surprised if its not for an RX-7 as the pattern including the retaining screw is in the same spots.
That being said - I'm fairlu sure there have been 14" kits offered - but we likely rarely see them as they require 18" rims depending on the caliper, (i.e. most all calipers would require an 18" rim).
-Bob
That being said - I'm fairlu sure there have been 14" kits offered - but we likely rarely see them as they require 18" rims depending on the caliper, (i.e. most all calipers would require an 18" rim).
-Bob
Thread
Thread Starter
Forum
Replies
Last Post