Volk Rays TE37 17" x 8.5 9.5 +40 (FD3S)
03-15-12, 10:38 AM
#1
Full Member
Thread Starter
Join Date: Jan 2003
Location: Australia
Posts: 58
Likes: 0
Received 0 Likes
on
0 Posts
Volk Rays TE37 17" x 8.5 9.5 +40 (FD3S)
Looking at buying a set of Volk Rays TE37 17" x 8.5 9.5 +40
Will a +40 offset be too much for the fd?
I have Tein Type Flex Coilovers and feed front fenders.
Thanks.
Will a +40 offset be too much for the fd?
I have Tein Type Flex Coilovers and feed front fenders.
Thanks.
03-15-12, 12:02 PM
#3
Full Member
Join Date: Jul 2007
Location: Seattle, WA
Posts: 205
Likes: 0
Received 0 Likes
on
0 Posts
you can also enter some of the numbers here and the site will give you a rough of an idea of how the wheels will fit vs the current
http://www.1010tires.com/wheeloffsetcalculator.asp
http://www.1010tires.com/wheeloffsetcalculator.asp
03-15-12, 07:29 PM
#4
Full Member
iTrader: (2)
Join Date: Feb 2009
Location: Ontario
Posts: 222
Likes: 0
Received 0 Likes
on
0 Posts
you can also enter some of the numbers here and the site will give you a rough of an idea of how the wheels will fit vs the current
http://www.1010tires.com/wheeloffsetcalculator.asp
http://www.1010tires.com/wheeloffsetcalculator.asp
Thats B.A
03-16-12, 05:58 PM
#5
Senior Member
iTrader: (49)
Join Date: May 2011
Location: Bay Area -> California
Posts: 338
Likes: 0
Received 0 Likes
on
0 Posts
I run 18 x 10 +43 on the rear.
285 tire width gets cut, barely (no rolling) ... but I'm fairly sure a 275 would be fine. I know a 265
03-16-12, 06:03 PM
#6
Senior Member
iTrader: (49)
Join Date: May 2011
Location: Bay Area -> California
Posts: 338
Likes: 0
Received 0 Likes
on
0 Posts
I'm running Volk GTN's btw (not that it matters much)
Also, if you're running a +40 offset, that should be far enough from the fender (considering you're only running 9.5")
Also, if you're running a +40 offset, that should be far enough from the fender (considering you're only running 9.5")
Last edited by perf0rmance; 03-16-12 at 06:21 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Turblown
Vendor Classifieds
12
10-17-20 03:25 PM
joel(PA)
Race Car Tech
0
10-01-15 10:25 AM
