Hi Guys,

I need your input on wheel size and offset. I'm finishing up with the rocket bunny on my FD. I'm going either 19 or 20 rim... But was wondering what width and offset would make it flush with my fender??

 

It depends on alignment, width, offset, and tire. It's literally like an infinite combination at this point. I believe they're 100 overs, so whatever's flush on stock metal, whatever sticks out 4" more will be a good starting point. Come back when you figure out what tire and width you want.

 

I agree... There are a million combinations you can run.


Steps:
1. Select desired rim width
2. Select desired tire size to match rim width
3. Finally choose your offset


Your going to want to select your desired wheel width and tire width before considering offset. Also if the rocket bunny kit is in fact 4" of flare that gives you roughly 180-200mm of room from hub mount surface to inner fender flare surface.


(90-100mm) Flush Rear Fitment
(80-90mm) Flush Front Fitment
add 4" of flare (101.6mm)


FRONT: 90 + 101.6 = 191.6mm
REAR: 80 + 101.6 = 181.6mm


This should give you a good base to start from when determining your offset. **This is based off 4" of flare as I do not know the exact width of the rocket bunny kit**