help with suspenion setup problems (with pics)
#1
Full Member
Thread Starter
Join Date: Jan 2006
Location: auckland
Posts: 59
Likes: 0
Received 0 Likes
on
0 Posts
help with suspenion setup problems (with pics)
ok guys i am having a bit of a problem..
i fitted d2 adjustables into my fc rx7.. but in the front i have come too a problem.. i have fitted and found that when i fit my front guards one side sits lower then the other.. eg one sitting just how i want it and the other being too low and hitting on the guard..
i have measured from the hub too the edge of the body of the car has pictured..
both sides measure too be the same.. but the right hand side is a little bit too low as pictured.
so i have been thinking and thought maybe my chassis is bent in same way.. so i was sitting down looking at my car and noticed the chassis bars that run thru the engine bay slightly look higher then the other..
so i got my levier out and measured between the chassis rails like so
and find that it sages down too the right..
but then i thort that maybe the floor of my garage could be out so i checked, it was unlevel but not by very much..
so was wondering if some one could shead some light on the matter..
i am thinking that my chassis rails are bent so would mean that i should get it up on a chassis straighter and get it fixed quickly so i dont run into problems when it comes too a wheel alignment.?
please help
i fitted d2 adjustables into my fc rx7.. but in the front i have come too a problem.. i have fitted and found that when i fit my front guards one side sits lower then the other.. eg one sitting just how i want it and the other being too low and hitting on the guard..
i have measured from the hub too the edge of the body of the car has pictured..
both sides measure too be the same.. but the right hand side is a little bit too low as pictured.
so i have been thinking and thought maybe my chassis is bent in same way.. so i was sitting down looking at my car and noticed the chassis bars that run thru the engine bay slightly look higher then the other..
so i got my levier out and measured between the chassis rails like so
and find that it sages down too the right..
but then i thort that maybe the floor of my garage could be out so i checked, it was unlevel but not by very much..
so was wondering if some one could shead some light on the matter..
i am thinking that my chassis rails are bent so would mean that i should get it up on a chassis straighter and get it fixed quickly so i dont run into problems when it comes too a wheel alignment.?
please help
Thread
Thread Starter
Forum
Replies
Last Post
82streetracer
1st Generation Specific (1979-1985)
7
08-23-15 09:28 AM