First time on the track with the FD...Gtech data included
#1
Got Rotors?
Thread Starter
iTrader: (1)
Join Date: Aug 2004
Location: Des Moines, Iowa
Posts: 580
Likes: 0
Received 0 Likes
on
0 Posts
First time on the track with the FD...Gtech data included
So i finally got the FD to the point where i was confident enough to track her and puch it to it's fullest. Overall it went very well. It was a total blast actually. I did miss half the track day since my greddy pulley set was delayed thanks to UPS but had fun non the less.
So now for some data...
My setup is full stock suspension except RP differential mounts and trailing arms.
Power wise i was sitting around 300 or so at 10psi.
Tires are Kumho MX's with no camber adjustments (ran out of time).
Track was MAM (search through Damian's videos for it...good stuff)
Also, ambient temps were in the low 90's and himidity was in the 60-70% range. My coolant temps were at 85-87 degrees Celsius, air intake temps were at 49 degrees celcius, and oil temps were around 100-105 degrees celcius. Damn i love this v-mount
If you have not tracked your FD.....DO IT! It's a blast
So now for some data...
My setup is full stock suspension except RP differential mounts and trailing arms.
Power wise i was sitting around 300 or so at 10psi.
Tires are Kumho MX's with no camber adjustments (ran out of time).
Track was MAM (search through Damian's videos for it...good stuff)
Also, ambient temps were in the low 90's and himidity was in the 60-70% range. My coolant temps were at 85-87 degrees Celsius, air intake temps were at 49 degrees celcius, and oil temps were around 100-105 degrees celcius. Damn i love this v-mount
If you have not tracked your FD.....DO IT! It's a blast
Thread
Thread Starter
Forum
Replies
Last Post
rx8volks
Canadian Forum
0
08-13-15 04:55 AM
rx8volks
Canadian Forum
0
08-11-15 10:30 PM