I guess this should be in FC, but all wheel studs I think are done the same so I think it's appropriate here. I have been trying to get the wheel studs out of my hub. A hammer won't get them out. So I tried a 2" gear puller rated at 1.5 tons. The gear puller snapped like a twig.



That stud is stuck.fast.

I know when I need to cry uncle. I am going to take both left and right knuckle/hubs clean off and take them to a shop I know. While they are off, I guess I should also do the DTSS bushings, the wheel bearings, and all 10 rear studs.