Can someone measure from tire to tire for me on a third gen?
#1
Senior Member
Thread Starter
iTrader: (10)
Join Date: Oct 2002
Location: Greensboro, NC
Posts: 463
Likes: 0
Received 0 Likes
on
0 Posts
Can someone measure from tire to tire for me on a third gen?
I am looking for the overall width from tire edge to tire edge, with stock rims if you have them on a 93-present.
Not looking for super accurate, but within a half inch is more than good enough. The rough measurements I got from a Junkyard shell were in the 65 inch range,(was a guess as there was no wheels or suspension).
I appreciate the few minutes it will take.
-Bob Hanvey
Not looking for super accurate, but within a half inch is more than good enough. The rough measurements I got from a Junkyard shell were in the 65 inch range,(was a guess as there was no wheels or suspension).
I appreciate the few minutes it will take.
-Bob Hanvey
#3
Senior Member
Thread Starter
iTrader: (10)
Join Date: Oct 2002
Location: Greensboro, NC
Posts: 463
Likes: 0
Received 0 Likes
on
0 Posts
To determine how much of a flare,(if any), I need to fit this under a 1973 Datsun 240Z. My current tire to tire width is just under 64 inches. I think I can squeeze 65 inches under stock fenders, but anything more requires flares,(fairly simple to do, the ones I want anyways).
I am transplanting the complete RX-7 front and rear suspensions to the 240Z as part of a project.
-Bob
I am transplanting the complete RX-7 front and rear suspensions to the 240Z as part of a project.
-Bob
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
rx7jocke
Suspension/Wheels/Tires/Brakes
72
06-17-16 03:48 AM