Brake rotors between na and t2
03-10-06, 01:20 AM
#1
JRLT'specs* White Comet
Thread Starter
Join Date: Apr 2004
Location: Altamonte Springs, Orlando, Florida, Usa
Posts: 255
Likes: 0
Received 0 Likes
on
0 Posts
Brake rotors between na and t2
Is the rearend hub center where you place your brake rotors bigger in a turbo II then a NA. Cuz i order some ebay cross drilled slotted rotors, but the rear end does not seems to fit. i will check the front end tomorrow. also is there a way to install them, or where to get a pair of them.
03-10-06, 07:15 AM
#2
Lives on the Forum
There are three different types of rear brake rotors for FC's.
4-lug (1986 - 1988, base non-turbo)
5-lug solid (1989 - 1991, base non-turbo)
5-lug vented (everything else, all Turbo II)
Are your rotors 4-lug or 5-lug?
Is it vented or solid?
-Ted
4-lug (1986 - 1988, base non-turbo)
5-lug solid (1989 - 1991, base non-turbo)
5-lug vented (everything else, all Turbo II)
Are your rotors 4-lug or 5-lug?
Is it vented or solid?
-Ted
03-10-06, 08:56 AM
#3
JRLT'specs* White Comet
Thread Starter
Join Date: Apr 2004
Location: Altamonte Springs, Orlando, Florida, Usa
Posts: 255
Likes: 0
Received 0 Likes
on
0 Posts
See i have 5 lugs, i have vented but for some reason the rotor that i order are slighly offset. The center area is way to small about half inch less in diameter, were as the outside circle is a bit to big about half inch more in diameter.
03-10-06, 09:13 AM
#4
JRLT'specs* White Comet
Thread Starter
Join Date: Apr 2004
Location: Altamonte Springs, Orlando, Florida, Usa
Posts: 255
Likes: 0
Received 0 Likes
on
0 Posts
See i have 5 lugs, i have vented but for some reason the rotor that i order are slighly offset. The center area is way to small about half inch less in diameter, were as the outside circle is a bit to big about half inch more in diameter.
Thread
Thread Starter
Forum
Replies
Last Post
Devon300zx
2nd Generation Specific (1986-1992)
15
09-16-15 06:57 AM
