88 rx7 rear left side caliper. need help
#1
Full Member
Thread Starter
Join Date: Mar 2009
Location: reading,pa
Posts: 74
Likes: 0
Received 0 Likes
on
0 Posts
88 rx7 rear left side caliper. need help
I removed all everything out of my way while changing my pads and rotors, I used a caliper rewind tool to push the pistion back in and it went in fine... but I had to call it quits because it got too dark to see so I firgued I would finish up tomorrow ie as in today........
so today i go out and i noticed the piston came back out on its own and wasn't not pushed in anymore after I done gone and had it in the bore yesturday.... so i'm like ok whatever i get the caliper rewind tool out again but this time the piston will not budge! I can sometimes budge it an inch or so but thats all.
whats my problem or what happen to it over night?
by the way this is an 88 non turbo 4 lug and its the rear left side on car caliper
so today i go out and i noticed the piston came back out on its own and wasn't not pushed in anymore after I done gone and had it in the bore yesturday.... so i'm like ok whatever i get the caliper rewind tool out again but this time the piston will not budge! I can sometimes budge it an inch or so but thats all.
whats my problem or what happen to it over night?
by the way this is an 88 non turbo 4 lug and its the rear left side on car caliper
Last edited by FCmidnight Blue 88; 04-23-09 at 03:32 PM.
#5
Full Member
Thread Starter
Join Date: Mar 2009
Location: reading,pa
Posts: 74
Likes: 0
Received 0 Likes
on
0 Posts
hmm yeah i unbolt the wheel, unbolt the caliper bolts, knocked out the old pads, then took the re-wind tool and tried turning the piston back in but it wont budge but the like i said eariler that night it did go all the way in, but next day when i went to finish up the car the piston was back out and doesn't wanna even budge now.