Super AFC can i get a vacuum/pressure signal?
Thread Starter
Joined: Jul 2002
Posts: 9,387
Likes: 4
From: Nashville, TN
can i get a vacuum/pressure signal?
i have an SAFC hooked up to my S5 TII and there are 3 wires not hooked up (wired via scott89t2's page) and i have no vacuum or boost reading... the wires left are pink, blue, and orange.
are one of these wires the wire needed for a boost/pressure signal?
are one of these wires the wire needed for a boost/pressure signal?
EIT
Joined: Jan 2002
Posts: 1,790
Likes: 0
From: Austin, TX
When you wire the safc via the pressure sensor you're actually using the wire that would be going to the TPS sensor. On the safc it will still show a TPS reading, but in reality it's an electric boost guage that shows percentages. I can't remember which wire color is for the tps, but solder that wire into the pressure sensor before the FCD.
EIT
Joined: Jan 2002
Posts: 1,790
Likes: 0
From: Austin, TX
When you wire the safc via the pressure sensor you're actually using the wire that would be going to the TPS sensor. On the safc it will still show a TPS reading, but in reality it's an electric boost guage that shows percentages. I can't remember which wire color is for the tps, but solder that wire into the pressure sensor before the FCD.
Thread
Thread Starter
Forum
Replies
Last Post
Adaptronic MTX-L to adaptronic question
TeamRuffRacing
Adaptronic Engine Mgmt - AUS
1
Sep 30, 2015 08:13 PM