DFW RX-7 July 2011, then August 6th Meet and now the September 10th Meet Thread...
I'm a relatively new member, and was curious if I would be able to attend, I live in the Roanoke area. Also if I may suggest a meeting place, how about Southlake town square there is plenty of room good lighting and food.
Last edited by Redliner223; Sep 16, 2011 at 11:25 AM. Reason: MY BRAIN
Thread Starter
There were no survivors
Joined: Aug 2004
Posts: 2,475
Likes: 1
From: Grand Prairie, Texas
The type of cars that show up are RX-7 owners in their dailys. 
I guess the meet will be at 635 and MacArthur BLVD in the parking lot behind Cheddars/Mc'Donalds @ 8PM as usual this meet and try someplace new for Oct. 1st since there wasn't a lot of input.

I guess the meet will be at 635 and MacArthur BLVD in the parking lot behind Cheddars/Mc'Donalds @ 8PM as usual this meet and try someplace new for Oct. 1st since there wasn't a lot of input.
I assume this weekend?
Address:
7750 North Macarthur blvd, Irving, TX.
He was just joking around, as many RX-7 owners don't always bring their cars because they're down. I'd say it's a pretty good selection of all generations, though.
Tomorrow saturday at 0800 pm at the intersection of McArthur Blvd and 635 LBJ in Irving. The # and type of RX7's varies from meet to meet. Come on out.
I'm looking out the windows from here at work and it's sunshine right outside of downtown Big D but a crazy gray haze everywhere else. Should be ok for a meet.
I've been forced to Saturday's again here at AT&T for the next two weeks, so I may not be able to make it. I'll try, though, if anything to make sure someone takes some pics this time around.
I've been forced to Saturday's again here at AT&T for the next two weeks, so I may not be able to make it. I'll try, though, if anything to make sure someone takes some pics this time around.

I'm a failure yet again... Worked on my car from 830am to 930 pm.
Completed:
Replaced turbos
Installed lightweight flywheel
Modified duct for IC
Installed new boost controller
Failed to come to rx7 meet once again
Completed:
Replaced turbos
Installed lightweight flywheel
Modified duct for IC
Installed new boost controller
Failed to come to rx7 meet once again
New cars! An SA and that crazy FB with a home-cooked widebody treatment. I was thinking along the same lines but I was going to make it more angular like "rommelwhoa's" FC but without the wing.
Thread
Thread Starter
Forum
Replies
Last Post
SakeBomb Garage
Group Buy & Product Dev. FD RX-7
8
Oct 9, 2015 10:05 PM
rx8volks
Canadian Forum
0
Sep 1, 2015 11:02 PM
rx8volks
Canadian Forum
0
Sep 1, 2015 10:46 PM









