were/what size to buy oil feed line for bw turbo ?
#1
were/what size to buy oil feed line for bw turbo ?
im looking for turbo feed line for a my s360 no idea were to get one i seen some on hmni racing and ebay . but for t series and gt series . i know the size they say to use on this turbo is a -3an . its for a fc s4 t2 . also if any one knows the drain size would help
#3
Rotary Freak
iTrader: (7)
You can make your own fairly easily with a couple of hose ends and some line. You will need an adapter for the front iron and an adapter for the turbo. I know people recomend using a -3, but I already had a -4 feed line from my previous setups so I just used it on my BW and I haven't seen any problems running it.
#4
You can make your own fairly easily with a couple of hose ends and some line. You will need an adapter for the front iron and an adapter for the turbo. I know people recomend using a -3, but I already had a -4 feed line from my previous setups so I just used it on my BW and I haven't seen any problems running it.
#5
I'm doing engine conversion project of 13BT REW engine. Just purchased the BW S300SX3 part number 177283. Since it's my very first to such engine conversion project, i need advice of what size of turbo oil line for both inlet and outlet of the turbo ?
Your reply is highly appreciated, thanks a lot.
Thread
Thread Starter
Forum
Replies
Last Post
Kyo
2nd Generation Specific (1986-1992)
3
08-14-15 02:00 PM
KAL797
Test Area 51
0
08-11-15 03:47 PM