using AVC-R to control with an external WG?
09-03-02, 08:09 PM
#1
Lives on the Forum
Thread Starter
using AVC-R to control with an external WG?
i have lost my manual and need to figure this out. it has been about 3 years since i hooked it up. a little rusty at this point. the manual will not load from the apex site for some reason, and i KNOW i have adobe reader. 
my questions goes as follows:
1. how should the hoses for solinoid be set up?
2. what wires to i have to splice into for a Haltech?
my current wiring harness is riped to shreads and the avc-r is out so it is not like i can even go over my prior instal.
maybe i will check out robrobinette's site for wires, but maybe some else knows off the top of their head.
- i do not need instruction on programing it, i already *schooled* myself enough on that when i got it to remember for ever.
T.I.A.
-Keith
my questions goes as follows:
1. how should the hoses for solinoid be set up?
2. what wires to i have to splice into for a Haltech?
my current wiring harness is riped to shreads and the avc-r is out so it is not like i can even go over my prior instal.
maybe i will check out robrobinette's site for wires, but maybe some else knows off the top of their head.
- i do not need instruction on programing it, i already *schooled* myself enough on that when i got it to remember for ever.
T.I.A.
-Keith
Thread
Thread Starter
Forum
Replies
Last Post
alexdimen
3rd Generation Specific (1993-2002)
20
10-23-15 01:50 PM