anyone running twin gt28rs set-up (this might not qualify in the single turbo section but whatever),

i am looking for 390-420 hp i will be using 650cc primary and 1200cc secondary injectors is this enough for these turbos

 

why twins?

 

twins are less eff. for a given flow rate, heavier, more complicated and you have 2x the potential weak links... twins, given the proven single turbo performance available , makes absolutely no sense.

 

Unless they are run sequentially.

 

Wow, what logic...


-Ted

 

totally

 

m2 performance use to machine the stock turbo housings to swap out the ht-12 for gt28r dual bb turbos two of these turbos can flow about 65 lbs.min

 

Well if you do it it would work, how do you plumb something like that though?

 

the m2s were t25s.

The BNR stage 3s are similar to what you're looking for, but of course they use a shared turbine housing and arent ball bearing.

 

hey rich are you still running the bnr's?

wonder if gt28r's will fit in the stock housings

 

Didn't RX7 Store used to have a kit? I'm going twin with Garrett T3/TO4E's.

 

Nope. I had the thirst for more boost than they could provide. Besides, I was running them non-sequential and missed the low end. Sequential BNRs are the hot ticket if you want an affordable twin setup, in my opinion.

Call up Bryan and see what he can do for you, www.BNRturbos.com.

 

I like the idea of two turbos, I'm building a twin gt30 setup with two bovs on a custom s.s. steel manifold currently. Should make around 550hp.