turboed 12a setup
07-22-03, 07:47 PM
#1
Full Member
Thread Starter
Join Date: Mar 2003
Location: New York
Posts: 133
Likes: 0
Received 0 Likes
on
0 Posts
turboed 12a setup
i've got a streetported 12a that im putting an s5 turbo and manifold on. its almost ready to go. i have some questions though
i know where to put the bov. but i need help on determining what wastegate and boost controller to use. im almost out of money so i need something not too expensive but quality is a neccessity as always. and i also need to know where and how to hook them up. thanks
i know where to put the bov. but i need help on determining what wastegate and boost controller to use. im almost out of money so i need something not too expensive but quality is a neccessity as always. and i also need to know where and how to hook them up. thanks
07-24-03, 02:39 AM
#2
Full Member
Join Date: Jun 2003
Location: honolulu
Posts: 157
Likes: 0
Received 0 Likes
on
0 Posts
buy a delta gate or a race gate from turbonetics. go to home depot and buy a air pressure regulator for a shop air compressor. to adjust boost just turn the ****. but you gotta be careful because you will experiance boost creep with this. but its the cheapest. $20 bucks for the reg.
07-24-03, 08:29 AM
#3
Full Member
Thread Starter
Join Date: Mar 2003
Location: New York
Posts: 133
Likes: 0
Received 0 Likes
on
0 Posts
do some bov's act as boost controllers too? or do i have to have a separate boost controller. also. i have a holley fuel regulator but its not the kind that varies for a turbo. i wont be runing any more than 10 psi will i really need a different regulator?
Thread
Thread Starter
Forum
Replies
Last Post
immanuel__7
2nd Generation Specific (1986-1992)
89
09-05-15 10:23 AM
