Ok so I am looking for some more advise on setting up a turbo on my 12a. I was going to try and leave most of the internals stock and push a small boost for now until I get some more money rounded up to do a port and seal job on the 12a. I have been looking at a 13b fc3s turbo manifold to install on my 12a. Is there a way to slot the bolt holes to make the 13b manifold fit the 12a. I find the 13b manifolds are cheaper than the 12a manifolds by $200-300. I am just wondering what you guys have done before that would save me some time and money rebuilding my engine after blowing it up from too big of a boost ect. Thanks for the help on advance.

 

What type of manifold are you looking at the 4 barrel setup.

 

This is what I was looking at...

 

Also this is going to be my first setup so I would like to start it off with a small boost and work upto the boost I like once I figure out all the stuff I hope you will all teach me.