I was just wondering where I would see full boost with a T-60 on a stock port FD motor? I've searched all anyone says is it spools quick, btu nothing spools as quick as twins haha. So I am guessin around 3000-3200?

 

all depends on your hot side, but with a 1.00, probably in the 3500ish range

 

What about a smaller hot side? OR will anything beloow 1.00 be too small? One of my buddies was telling me anything smaller then 1.00 was too small even for a stock port.

 

you will find A/R0.8x exhaust side OK for stock- port engine.

REgards
Iwan

 

a lot depends on what you're going for.

a .81 (undivided), or .84 (divided) are fine for around the high 300/low 400 range on pump gas. anything much beyond that risks too much backpressure.