Sizing turbine housing and wheel
#1
Hot Dicken's Cider
Thread Starter
iTrader: (2)
Join Date: May 2003
Location: Marion, Ohio
Posts: 1,428
Likes: 0
Received 0 Likes
on
0 Posts
Sizing turbine housing and wheel
Im going to be ordering a Turbonetics 62-1 this week, but Im not sure on what size turbine housing to get. I want to put down 430ish at 16psi with a medium-large streetport. What would the best turbine housing a/r and wheel size be? Im thinking a 1.00 with a P trim, but I dont know anyone who has anything similar.
#2
Senior Member
Hot Side
that sounds about right to me...
i dont feel the Q is worth the extra money and worst of all the parts are less common/harder to come by if you were to need to swap housings or get a new turbine later
most making that HP are in the .9-1.1 A/R range
justin
i dont feel the Q is worth the extra money and worst of all the parts are less common/harder to come by if you were to need to swap housings or get a new turbine later
most making that HP are in the .9-1.1 A/R range
justin
Thread
Thread Starter
Forum
Replies
Last Post
jetlude
Single Turbo RX-7's
4
08-18-15 04:53 PM