single turbo install
11-17-01, 04:09 PM
#1
Junior Member
Thread Starter
Join Date: Apr 2001
Location: Mo
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
single turbo install
I am going to purchase a Greddy T-88 kit and large FMIC from Greddy and I am curious of what I will need to complete the install of the actuall turbo. I am wondering do I have to buy a intercooler pipe kit and blow off valve? I am just trying to figure out what I will have invested in the single set up minus fuel and spark. This is going on an 3g rx7 that is built for drag use but it will not be all out drag because it would be a shame to do that to a rx7. thanks for the help.
11-18-01, 05:37 AM
#2
Eats, Sleeps, Dreams Rotary
iTrader: (2)
When you buy the greddy front mount, make sure you get one for single turbo so it comes with a pipe to fit your single turbo. For fuel, you need to get a high flow fuel pump, larger upgraded stock injectors or use custom fuel rail with bosch injectors. Just go to my website and check out my mods. You can copy my setup.
Chuck
Chuck
11-18-01, 01:54 PM
#3
Junior Member
Thread Starter
Join Date: Apr 2001
Location: Mo
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
thanks for the response. So when I buy the turbo and intercooler all of the piping should be included and all I need to buy is the blow off valve. I am going to run haltech with 1600cc secondaries with high flow fuel pump. I will look over the site.
