GSB

Hiya guys,

Right no damage done, however when the car was running on the rollers the rpm reached 6100 before suddenly cutting off, i'm unsure why as this has not happened before.

I do however have a new boost controller which i'm not sure is set up correctly, could it have a boost time on it so say after 10 secs shuts the boost off ??? is this possible ??

The AFR was just under 10 , and the boost was consisent @ 13PSI so no problems there as such.

Any ideas guys.

Running a T78 set up to run 1bar boost 550 primaries, 1300 secondaries, Apexi BNR 33 fuel pump, Power FC and HKS EVCR revision 3 boost controller.

Thanks,

Gurj.

dubulup

too rich and ignition breakup/failure?? what ignition system are you running?

cewrx7r1

iTrader: (2)

I hope you have the PFC boost set higher than what you are controlling with the
HKS EVCR revision 3 boost controller.

If not, the PFC will fuel cut!

GSB

I think the PFC boost level was lower than the boost controller setting, will be looking into this, thankyou for the help.