rear oil return block off?
09-10-03, 04:05 PM
#2
Senior Member
Join Date: May 2002
Location: Frisco, TX
Posts: 281
Likes: 0
Received 0 Likes
on
0 Posts
I just cut off the middle flange from the front oil drain, flared the line a little, and attached an-12 drain line from my turbo to it with a clamp.
For the block-off plate, I'm not sure. It probably wouldn't be hard to make one yourself, or you could weld shut the old line.
For the block-off plate, I'm not sure. It probably wouldn't be hard to make one yourself, or you could weld shut the old line.
09-11-03, 11:50 PM
#6
Rotary Freak
Join Date: Jan 2002
Location: Overland Park, KS
Posts: 2,360
Likes: 0
Received 0 Likes
on
0 Posts
With the front return I just cut the pipe in half and bought a steal -12to-12 and had it welded to the end. I had to make sure it was far enough out to clear parts of the block with being so large and all. PM me if you want any pics.
~Luke
~Luke
Last edited by c00lduke; 09-11-03 at 11:53 PM.
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
stickmantijuana
20B Forum
8
08-18-15 02:46 PM
KAL797
Test Area 51
0
08-11-15 03:47 PM