Pulleys with single turbo
#1
Full Member
Thread Starter
Join Date: Mar 2001
Location: ST. CROIX VIRGIN ISLANDS
Posts: 237
Likes: 0
Received 0 Likes
on
0 Posts
Pulleys with single turbo
I am planning on going single turbo on my 3rd gen. I will be removing the airpump, do I have to get under drive pulleys becuase the abscence of the aripump or can I just get a smaller belt to run the alt and water pump?
#2
I don't think you have to get different pulleys, but I already had an underdrive main pulley so I ended up getting a Water Pump and Alternator pulley from SR Motorsports to increase the contact on the water pump. It does not look like it has slipped at all, which is something I was worried about. Running an underdrive main pulley with the stock WP and Alt pulleys would probably not be a good idea.
I used a Gates K050290 (5-rib, 29.0") belt purchased locally for less than $10. It was special order, but they were able to get it just a few hours after I came in to place the order. You can find a Gates distributor on their web site http://www.gates.com/
Stock pulleys would probably require a longer belt.
I used a Gates K050290 (5-rib, 29.0") belt purchased locally for less than $10. It was special order, but they were able to get it just a few hours after I came in to place the order. You can find a Gates distributor on their web site http://www.gates.com/
Stock pulleys would probably require a longer belt.
Thread
Thread Starter
Forum
Replies
Last Post
sherff
Adaptronic Engine Mgmt - AUS
9
02-24-19 12:09 PM
stickmantijuana
3rd Generation Specific (1993-2002)
5
01-11-16 04:08 PM
stickmantijuana
Engine Management Forum
11
11-09-15 01:15 PM
stickmantijuana
Single Turbo RX-7's
0
08-21-15 08:35 PM