Profec B Spec II - controller port size?
Joined: Nov 2002
Posts: 1,790
Likes: 3
From: Travis AFB, CA to Okinawa, Japan
I'm sure there is, but I don't think anybody has looked at the threads. What are you trying to do? Convert to AN lines?
It wouldn't hurt just to try a little 1/8 nipple from plumbing hardware and see if it threads.
It wouldn't hurt just to try a little 1/8 nipple from plumbing hardware and see if it threads.
Thread Starter
thats not paint....
Joined: May 2001
Posts: 2,231
Likes: 2
From: Manassas, VA
Originally Posted by 95nracer
I'm sure there is, but I don't think anybody has looked at the threads. What are you trying to do? Convert to AN lines?
It wouldn't hurt just to try a little 1/8 nipple from plumbing hardware and see if it threads.
It wouldn't hurt just to try a little 1/8 nipple from plumbing hardware and see if it threads.
Mark White admirer
Joined: May 2004
Posts: 74
Likes: 0
From: Slidell, LA
It is M10 x 1.5, this is close to 1/8 X 27 NPT. If you want to change it to AN, put a little grease on the 1/8" tap and open it up about 4 or 5 turns. Clean any residual flakes carefully.
Barry
Barry
Thread
Thread Starter
Forum
Replies
Last Post
Frisky Arab
2nd Generation Specific (1986-1992)
13
Aug 18, 2015 05:30 PM
KAL797
Test Area 51
0
Aug 11, 2015 03:47 PM