Precision T&E 550cc (55 lb/hr)injectors don't fit!
#1
Rotary Freak
Thread Starter
iTrader: (1)
Join Date: Feb 2001
Location: Sinking Spring Pa.
Posts: 1,790
Likes: 0
Received 0 Likes
on
0 Posts
Precision T&E 550cc (55 lb/hr)injectors don't fit!
Whats the deal here, I have an 87' T2 im trying to put these in. Alot of people say they bought there injectors from Precision did anyone else have a prolbem? The nozzle part of the injector that accually gets inserted into the engine is too big. Help me I need to get this engine done sometime this century!
Thanks,
Brian
Thanks,
Brian
#2
Full Member
Join Date: May 2001
Location: 4th Quadrant
Posts: 212
Likes: 0
Received 0 Likes
on
0 Posts
Is the end bare metal or does it have a plastic cap?
If it has a plastic cap, try to remove it. After removing the plastic cap it should look like you stock "nozzle part".
If it has a plastic cap, try to remove it. After removing the plastic cap it should look like you stock "nozzle part".
#4
Full Member
Join Date: May 2001
Location: 4th Quadrant
Posts: 212
Likes: 0
Received 0 Likes
on
0 Posts
Be careful.
Originally posted by 1FastT2
Bare metal, after looking over some stuff tonight, I was thinking that I may be able to drill the air bleed things out a little bit.
Bare metal, after looking over some stuff tonight, I was thinking that I may be able to drill the air bleed things out a little bit.
Be extra careful, those things are extremly brittle especially when old.