Part number of K&N filter for GT35R
#2
sdrawkcab
iTrader: (1)
Any 4 inch Mounting Flange Inside Diameter should work fine, providing that it fits in your allotted space.
The bigger the better I think so try and squeeze the biggest i.e. Most surface area one you can fit in there.
What components are you running that make the size a restriction IC, position of manifold, old versus new 35R manifold? Because that will change what you can fit in there.
Just remember that you usually need to subtract an inch off of the measured length for a given filter to alot for the mounting coupler and wiggle room when installing.
The bigger the better I think so try and squeeze the biggest i.e. Most surface area one you can fit in there.
What components are you running that make the size a restriction IC, position of manifold, old versus new 35R manifold? Because that will change what you can fit in there.
Just remember that you usually need to subtract an inch off of the measured length for a given filter to alot for the mounting coupler and wiggle room when installing.
Thread
Thread Starter
Forum
Replies
Last Post
diabolical1
2nd Generation Specific (1986-1992)
30
01-30-16 05:50 AM
josef 91 vert
2nd Generation Specific (1986-1992)
23
09-03-15 11:20 AM