my single turbo conversion
#1
Full Member
Thread Starter
Join Date: Feb 2005
Location: new zealand
Posts: 197
Likes: 0
Received 0 Likes
on
0 Posts
my single turbo conversion
hey guys i have got some choice info and help off here thanks heaps! so i though i would try give something back. the best i can do is a few pics and info on my build! it all started after a crap dyno tune where 2000kms after my motor just detonated and it was all over! anyway we got a series 8 crate motor and thanks to mark jullian from res in auckland he pulled it apart did a half bridge cos i love to pulse and extented port, pt seals got it all dowled and ballanced. then we have a garret t04z turbo a custom manifold/exhaust system/heat shield courtesy of herbert fabrication in auckland. a pwr intercooler and radiator and expansion tank, the clutch and flywheel have been upgraded i think they might be hks but not sure! nolothane engine mounts, a mazda speed 2way lsd diff, just purchased a microtech and controller, a vasnquish front bumper and a vented carbon fibre bonnet to try cool everything down an after market lower intake manifold which is suppose to give 30% increase in flow after market fuel rails, looking into a surge tank and duel pump fuel system at the mo as well as a bigger throttle body there heaps more that i cant think of right now 2!
Any suggestions for a good horse power gain that we have missed?
I will try add some pics
Cheers Mark
Any suggestions for a good horse power gain that we have missed?
I will try add some pics
Cheers Mark
Thread
Thread Starter
Forum
Replies
Last Post
stickmantijuana
3rd Generation Specific (1993-2002)
5
01-11-16 04:08 PM
stickmantijuana
Single Turbo RX-7's
0
08-21-15 08:35 PM