my almost finished project
04-01-02, 07:17 PM
#1
Senior Member
Thread Starter
Join Date: Feb 2001
Location: GA
Posts: 652
Likes: 0
Received 0 Likes
on
0 Posts
my almost finished project
I am just about finished my single turbo project. I have still have a few kinks to iron out but I thought I would show you guys how it looks so far. It's a T04E with a 60-1 compressor wheel, .6 comp, .96 turbine on center. I'll post more pics with dyno numbers when the project if fully complete.
http://24.26.32.23:81/silver7/share/...o/DSCF0014.JPG
http://24.26.32.23:81/silver7/share/...o/DSCF0015.JPG
http://24.26.32.23:81/silver7/share/...o/DSCF0014.JPG
http://24.26.32.23:81/silver7/share/...o/DSCF0015.JPG
04-02-02, 03:01 PM
#5
Senior Member
Thread Starter
Join Date: Feb 2001
Location: GA
Posts: 652
Likes: 0
Received 0 Likes
on
0 Posts
My goal is 400 rwhp at 15-16 psi. I know for a fact that I'm not there yet (butt dyno). I still need to tune it with a wide band. I don't know what "story" you are referrig to greg, but it was a nice challenge to figure out how I was going to connect the turbo the the manifold. I just handed the guy all my "extra" piping and told him to weld it so it fits. It turned out rather good I thought. BTW, that pipe going from my turbo to my IC is my M2 crossover pipe with an elbow welded to it. As you can see, the IC had to be modified as well.
Thread
Thread Starter
Forum
Replies
Last Post