Intake vacuum question.(can I make a Vac manifold?)
#1
Retired Moderator, RIP
Thread Starter
iTrader: (142)
Join Date: Sep 2005
Location: Smiths Falls.(near Ottawa!.Mapquest IT!)
Posts: 25,581
Likes: 0
Received 131 Likes
on
114 Posts
Intake vacuum question.(can I make a Vac manifold?)
This is on an S5 FC TII..running Haltech and a bunch of other stuff!
I got this "bright idea" to make a vacuum manifold up with multiple ports,so My vacuum source would be off of the source that the brakes use.
I assume that the brakes "see boost" too,so that is why they have a check valve in the hose at the booster.
My idea is to run some stuff,like my EBC and Boost gauge and my Brakes all off the same port.
Is this Possible?Here is a couple pics of the Part that I would like to use as a Distribution block.I will run a hose to the pipe( that is cut already) at the manifold.
The source being the banjo bolt that supplies Brake vacuum.
any Suggestions?Comments?
thanks.
I got this "bright idea" to make a vacuum manifold up with multiple ports,so My vacuum source would be off of the source that the brakes use.
I assume that the brakes "see boost" too,so that is why they have a check valve in the hose at the booster.
My idea is to run some stuff,like my EBC and Boost gauge and my Brakes all off the same port.
Is this Possible?Here is a couple pics of the Part that I would like to use as a Distribution block.I will run a hose to the pipe( that is cut already) at the manifold.
The source being the banjo bolt that supplies Brake vacuum.
any Suggestions?Comments?
thanks.
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
turbo-minivan
General Rotary Tech Support
69
02-04-16 12:29 AM