Injector insulator question
03-19-02, 05:15 PM
#1
Junior Member
Thread Starter
Join Date: Oct 2001
Location: kenner, louisiana
Posts: 9
Likes: 0
Received 0 Likes
on
0 Posts
Injector insulator question
I'm rebuilding and replacing the o-rings on my primary injectors b/c they were leaking. Should I remove the primary injector holder and replace the insulators beneath, or is this not a common leak point.
Car is 3rd gen RX7
also, i replaced my leaky pulsation damper.
Thanks Troy
Car is 3rd gen RX7
also, i replaced my leaky pulsation damper.
Thanks Troy
Last edited by TROYRUSSO; 03-20-02 at 09:17 AM.
03-22-02, 01:30 AM
#5
Senior Member
Join Date: Feb 2001
Location: los angeles CA
Posts: 339
Likes: 0
Received 0 Likes
on
0 Posts
Troy, I don't know if you "need" to replace them. I recently changed mine out. I didn't want to put EVERYTHING back in, just to have to take them out again to replace two $4.00 rubber insulators. YMMV
eric
eric
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
Skeese
Adaptronic Engine Mgmt - AUS
65
03-28-17 03:30 PM
