I'm still not finished. I just have it tacked together for fitment, I still have to do a couple adjustments.

 

Looks good.
You check it for fitment I hope? It sure looks like the #1 runner would be a tight fit in a FD chassis.

 

Thanks! Yes I did. It bends and curves up right along the frame and subframe. Joey is coming over to finish wiring the MicroTech on Sunday so I can atleast start the car without the turbo. My project is almost done finally.

 

looking good. hope to see some number one it soon. good luck

 

looking good. hope to see some number on it soon. good luck

 

looks pretty good so far. how thick is that engine flange? are you shooting for any specific numbers or are you just going to get the best tune with what you have and see where you end up?

 

The flange is 1/2" 304SS. I don't have any specific numbers I'm shooting for, but when its done I'm filling the tank up with C16 and turning the boost to 30 lbs and see what I get.

 

Sounds like what I am doing in December as well. Let us know how it turns out. And, I'll so the same!!!

Dee