G-Force w/ Single turbo set-up
#1
Senior Member
Thread Starter
iTrader: (1)
Join Date: Apr 2001
Posts: 591
Likes: 0
Received 0 Likes
on
0 Posts
G-Force w/ Single turbo set-up
Have any of you installed the G-Force with a single turbo set-up?
I'm re-wiring my set-up with the G-Force ECU until I get my E6K (my current E6K is in the FC, daily driver).
The car starts and idles fine.
However, I get no tach, no speedo, no mileage (it's fine when the car is in ACC mode), and the coolant and oil pressure gauges are off.
I was told that you need to "boot strap" the stock ECU by tricking it with a load (resistor or solenoid) for some of the fuel stuff (air split, relief, etc).
Has anybody run into this behavior?
J
btw, I can't wait for a better EMS to arrive.
I'm re-wiring my set-up with the G-Force ECU until I get my E6K (my current E6K is in the FC, daily driver).
The car starts and idles fine.
However, I get no tach, no speedo, no mileage (it's fine when the car is in ACC mode), and the coolant and oil pressure gauges are off.
I was told that you need to "boot strap" the stock ECU by tricking it with a load (resistor or solenoid) for some of the fuel stuff (air split, relief, etc).
Has anybody run into this behavior?
J
btw, I can't wait for a better EMS to arrive.
Thread
Thread Starter
Forum
Replies
Last Post
stickmantijuana
3rd Generation Specific (1993-2002)
5
01-11-16 04:08 PM
stickmantijuana
Single Turbo RX-7's
0
08-21-15 08:35 PM