Fuel return line size.
#1
Rotary Freak
Thread Starter
Join Date: Nov 2001
Location: trinidad and tobago
Posts: 2,715
Likes: 0
Received 0 Likes
on
0 Posts
Fuel return line size.
Dont think I am reposting since I cant find my previous one (moderators ?) , anyway , I finally got my twin Bosch '044 pumps installed and will be starting up tomorrow (after I get my 180 deg fittings) , I was told that those pumps would cause an idle pressure of about 60 psi with the stock return line , can anyon say if this is so or not ?.
#5
Lives on the Forum
It depends on your feed size?
As a rule of thumb, you go down one AN size versus the feed size.
-8AN feed, -6AN return
-10AN feed, -8AN return
-Ted
As a rule of thumb, you go down one AN size versus the feed size.
-8AN feed, -6AN return
-10AN feed, -8AN return
-Ted
Last edited by RETed; 04-02-04 at 05:09 PM.
#6
Rotary Freak
Thread Starter
Join Date: Nov 2001
Location: trinidad and tobago
Posts: 2,715
Likes: 0
Received 0 Likes
on
0 Posts
i am running - 8 AN from the pumps into a NOS Y fitting , from which it goes to a -10 AN supply hose , the -6 return is attached to the stock return line.
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
KAL797
Test Area 51
0
08-11-15 03:47 PM