Fd single turbo running super rich
#1
Full Member
Thread Starter
Join Date: Oct 2015
Location: cambridge
Posts: 63
Likes: 0
Received 0 Likes
on
0 Posts
Fd single turbo running super rich
Hi all
Just had my engine fitted and had some trouble getting it to start. It won't start unless I give it a sniff of easy start.
It's a single turbo running on a pfc with hand controller, 1680 injectors, sytec fuel pressure regulator and Walbro pump.
Once it starts it misfires badly and smokes grey out the exhaust, it stinks of fuel from the exhaust both burnt and unburnt. Literally makes your eyes water.
The pfc isn't getting a coolant sensor signal and just says this
Water temp : ----
When I remove the big brake vac hose it runs slightly better but still alot worse.
Any suggestions there's a video of it running here
http://s551.photobucket.com/user/curtreid8/media/Mobile%20Uploads/20160428_183733_zpsontdaqv4.mp4.html
Just had my engine fitted and had some trouble getting it to start. It won't start unless I give it a sniff of easy start.
It's a single turbo running on a pfc with hand controller, 1680 injectors, sytec fuel pressure regulator and Walbro pump.
Once it starts it misfires badly and smokes grey out the exhaust, it stinks of fuel from the exhaust both burnt and unburnt. Literally makes your eyes water.
The pfc isn't getting a coolant sensor signal and just says this
Water temp : ----
When I remove the big brake vac hose it runs slightly better but still alot worse.
Any suggestions there's a video of it running here
http://s551.photobucket.com/user/curtreid8/media/Mobile%20Uploads/20160428_183733_zpsontdaqv4.mp4.html
Last edited by curtreid8; 04-29-16 at 03:02 PM.
#3
Full Member
Thread Starter
Join Date: Oct 2015
Location: cambridge
Posts: 63
Likes: 0
Received 0 Likes
on
0 Posts
Thanks for the reply the pfc was running the same single turbo and Injectors on a donor car. I swapped the lot onto mine
#4
Full Member
Thread Starter
Join Date: Oct 2015
Location: cambridge
Posts: 63
Likes: 0
Received 0 Likes
on
0 Posts
Thanks for the reply the pfc was running the same single turbo and Injectors on a donor car. I swapped the lot onto mine
#5
RX-7 Bad Ass
iTrader: (55)
Water temp is the problem. If the PFC isn't getting the signal from the 2-wire water temp sensor on the back of the water pump housing it can't compensate for the motor being cold. This is one of the primary inputs to any fuel injection system. Figure out why that isn't getting a signal, that should take care of it, or at least make things far better.
Dale
Dale
#6
Full Member
Thread Starter
Join Date: Oct 2015
Location: cambridge
Posts: 63
Likes: 0
Received 0 Likes
on
0 Posts
Thanks Dale, I found out that the earth wire (brown/black) was not connected to ground. I followed it back to the ecu and there it was disconnected into a chock block. I took this off and ran it to the ecu ground and I had a temp reading that was accurate! Mega
Now it's still running bad but it is alot better. I took a vid of what's going on to me it sounds like the timing is out. And it struggles to start on its own.
Now it's still running bad but it is alot better. I took a vid of what's going on to me it sounds like the timing is out. And it struggles to start on its own.
Thread
Thread Starter
Forum
Replies
Last Post
FRFC3S
2nd Generation Specific (1986-1992)
6
03-28-16 01:55 PM
Adaptronic Looking for a base map for single turbo S8
Charlieparker
Adaptronic Engine Mgmt - AUS
5
03-18-16 02:39 PM