Dual SBC Spec R digi boost controller
#1
Full Member
Thread Starter
Join Date: Dec 2001
Location: Irvine
Posts: 143
Likes: 0
Received 0 Likes
on
0 Posts
Dual SBC Spec R digi boost controller
The dual Solenoid setup, plumbing the pressure tubes from the wastegate to this controller, in the instructions it says the bottom line of the external wastegate goes to the turbo outlet, and to the "in" portion of the solenoid of the boost controller i have to put to the boost tube at the throttle body. Should I put both these inputs as close to the turbo as possible, with two nipples next to each other? Does it matter where these two nipples are as long as they are before the throttle body? Any insight will help.
Thanks,
Ravi
Thanks,
Ravi
Thread
Thread Starter
Forum
Replies
Last Post
Skeese
Adaptronic Engine Mgmt - AUS
65
03-28-17 03:30 PM