Ceramic Coating...
#1
Rotary Enthusiast
Thread Starter
iTrader: (1)
Join Date: Sep 2002
Location: Chicago, IL
Posts: 1,462
Likes: 0
Received 0 Likes
on
0 Posts
Ceramic Coating...
Where can I get ceramic coating done? I want to get my down pipe and manifold ceramic coated.
I have found a place, but they said 150 per piece, that seems like a lot.
Edan
I have found a place, but they said 150 per piece, that seems like a lot.
Edan
#2
Senior Member
Join Date: Feb 2001
Location: Glendale, AZ
Posts: 337
Likes: 0
Received 0 Likes
on
0 Posts
call HPC coatings.. they're here in PHX area. Did an excellent job on my stuff. they have in shop 1300 deg and out of shop 2300 deg stuff. the 2300 deg stuff is expensive. they did almost everything in my engine bay for $250ish. looks very good.
another place here in PHX area is Jet Hot Coatings, they do a good job too but i believe charge a bit more.
J
another place here in PHX area is Jet Hot Coatings, they do a good job too but i believe charge a bit more.
J
#4
Learned alot | Alot to go
iTrader: (2)
Join Date: Apr 2002
Location: Rotaryland, New Hampshire
Posts: 4,232
Likes: 0
Received 0 Likes
on
0 Posts
http://www.hpcoatings.com/
Funny, because i just was at this site today. The hot side of my turbo is being done by them though cheapturbo, i plan on sending my manifold there once it comes in
-Jacob
Funny, because i just was at this site today. The hot side of my turbo is being done by them though cheapturbo, i plan on sending my manifold there once it comes in
-Jacob