Keith at KGParts just recommended these

Bosch 210lb 2200cc High Injectors

with these adaptors

11mm Short EV14 NGI-2 Injector Adaptor Hat

From the research I've done I'm pretty sure these will fit m FC but what concerns me is that these are high impedance where my FC has the low impedance injectors. What mod do I need to do to run these?

Thanks,

~Anthony

 

remove your resistor pack

 

Is there a resistor pack for primaries and secondaries? My primaries will still be low impedance.

 

Search NGI-2. That is the Bosch designation for that injector. They can be had even cheaper.

 

I already purchased them but you're right...looked them up on ebay and they're $40 cheaper per injector . I don't understand why all these injector vendors sell the same injector at such different prices. Oh well.

Anyway back to my last question....being that my primaries are low impedance is there a resistor pack for both primary and secondary so I can just remove the secondary? What will be the tell tale sign if the impedance is mismatched once I start the car?

Thanks

 

This may be the answer to my questions...just had to find the right search keywords

https://www.rx7club.com/2nd-generati...w-help-765219/

 

Could use some advice guys. I located the injector resistor, it appears there's just one that is inline for both primary and secondary injectors. If I remove it and jump the wires my secondary injectors should work fine but now my primary injectors will still be low impedance. Any suggestions for the primaries if I bypass the resistor pack?