armanielite

Does anyone know what the torque specs are for the downpipe bolts for the t-78 and also the torque specs for the bolts connecting the manifold to the compressor inlet?

nashman69g

iTrader: (3)

do the bolts for the manifold side go into the turbo or into the manifold...If it the manifold I would say they should be the same as the stock turbo--I'd have to look that up in the FSM. As far the downpipe bolts try the stock numbers also...The torque should be within the same ballpark as long as they are similar in size and thread count! But if someone has more/better info than that please post!

armanielite

im not sure what stock specs are ...

nashman69g

iTrader: (3)

I'll look them up in the FSM when I get home...or you can go to www.iluvmyrx7.com and get the FSM there!

nashman69g

iTrader: (3)

In the FSM 32-42 ft-lb for turbo-manifold ..........28-38 ft-lb for the exhaust-turbo.

armanielite

ok thanks..hope its the same for the t-78

darkphantom

iTrader: (2)

THEY ARE CAUSE WHEN I Installed my t78 i used the same bolts for the mainfold. they should fit. except one i think on the bottom right. that one i had to get from somewhere else

armanielite

so the torque spec are roughly the same.... good deal then