apex boost control solenoid, is this right?
#1
R. R. R.
Thread Starter
Join Date: Jun 2004
Location: san jose
Posts: 1,892
Likes: 0
Received 0 Likes
on
0 Posts
apex boost control solenoid, is this right?
Ok I have the boost control solenoid kit with usage of a Power FC and an hks standard wastegate
Correct me if i'm wrong, here's how i'm hooking it up
-harness to the connector by the uim with the white dot
-two hoses on each end of the solenoid, one to turbo reference and another to the side of the wastegate
-top nipple on hks wastegate not connected.
Let me know if I've messed up somewhere.
Correct me if i'm wrong, here's how i'm hooking it up
-harness to the connector by the uim with the white dot
-two hoses on each end of the solenoid, one to turbo reference and another to the side of the wastegate
-top nipple on hks wastegate not connected.
Let me know if I've messed up somewhere.
#2
Speed Mach Go Go Go
iTrader: (2)
Join Date: Oct 2001
Location: My 350Z Roadster kicks my RX7's butt
Posts: 4,772
Likes: 0
Received 2 Likes
on
2 Posts
Not sure about which connector, since each place I go to changes it and there are three possibilities. I still don't know if mine is correct.
Read up on duty cycle I found one end to compressor and the other to wastegate. I have both nipples connected on my Tial.
It is the exact same solenoid used with the AVC-R and Greddy. So it may be easier to find instructions for those. I think I have the Greddy manual in my garage.
Read up on duty cycle I found one end to compressor and the other to wastegate. I have both nipples connected on my Tial.
It is the exact same solenoid used with the AVC-R and Greddy. So it may be easier to find instructions for those. I think I have the Greddy manual in my garage.
Thread
Thread Starter
Forum
Replies
Last Post
Skeese
Adaptronic Engine Mgmt - AUS
65
03-28-17 03:30 PM