any one used the Haltech f9 or f10
Thread Starter
Senior Member
Joined: Dec 2001
Posts: 378
Likes: 1
From: nm
any one used the Haltech f9 or f10
just want to know if any one has used the Haltech f9 or f10 on there turbo, i have a to4 turbo,10psi, 2 mm apx, p bridge, stock computer and want to go with the f 10 and run the 12a distributor with msd6al box.
Rotary Enthusiast
Joined: May 2002
Posts: 885
Likes: 2
From: Canberra - Aus
It should work fine, but you'd be much better off with an ECU capable of ignition control as well.
There is a member of Ausrotary.com that uses an F9 to control his standard 13BT - FB. Works well.
There is a member of Ausrotary.com that uses an F9 to control his standard 13BT - FB. Works well.
'Tuna'
Joined: Feb 2001
Posts: 4,637
Likes: 3
From: Miami,Fl,USA
I've done it many times before and run the same setup on my race car. Depending on your goals and intended use especialy if it's a daily driver you might want to consider some type of ignition control like S2-13BT suggested above.
crispeed
87 RX-7 TII
9.204@150.47mph
2600lbs
un-tubbed
crispeed
87 RX-7 TII
9.204@150.47mph
2600lbs
un-tubbed
